Marcel Equipment Limited (69 listings)

CAT 980M (2019) UNIT# L4593
MACHINE HOURS: 8075
ECM IDLE HOURS: 3125
LOAD FACTOR: 14%
This 980M CAT features an Aggregate Arrangement, CAT Payload System, CAT 7.75 CYD Bucket, Bridgestone VSNT L4 29.5R25 Tires, Joystick Bucket Control, Rear View Camera, and All Needed Repairs & Servicing Have Been Completed. Spade Rock Bucket & L-5 Tire Options Are Available

This caterpillar front end loader features:
• CAT C13 ACERT Engine
• Block Heater
• Powershift Transmission
• Cab (ROPS) w/ A/C
• Joystick Steering
• Ride Control
• Aggregate Arrangement
• CAT Payload System
• Autodig Function
• Bridgestone VSNT L4 29.5R25 Tires
• NEW L5 Tire Option Available
• CAT 7.75 CYD GP Bucket
• CAT 7.5 CYD Spade Nose Bucket Available
• Rear View Camera
• Axle Oil Coolers
• Joystick Bucket Control
• Powered Heated Rear View Mirror
• Remote Door Opener
• Halogen Flood Light Arrangement
• Rated at 425 HP
• Weight 67,000 LBS

The following are repairs completed by the CAT dealer prior to Marcel Equipment owning this CAT 980M Wheel Loader:
At 5,429 hours, performed 500 hour service
At 4,861 hours, performed 5,000 hour service
At 4,412 hours, performed 500 hour service
At 3,985 hours, performed 2,000 hour service
At 3,378 hours, performed 500 hour service
At 2,903 hours, performed 3,000 hour service
At 2,494 hours, performed 500 hour service
At 1,976 hours, performed 2,000 hour service
At 891 hours, performed 500 hour service
At 792 hours, installed NEW seat air compressor

The following was completed by Marcel Equipment on this used caterpillar wheel loaders for sale @ 7,347 hours:
Upon arrival to our yard, machine was stripped for power washing
Machine was inspected visually & operationally
Engine oil filter was cut open - clean
Transmission filter was cut open - clean
Hydraulic filter was cut open - clean
Axle oils were checked - levels good & oil clean

The following pressures were taken to ensure within OEM spec:
• Engine oil
• Fuel
• Engine boost
• Full stall & double stall
• Transmission main
• Torque converter inlet & outlet
• Transmission lube
• Transmission lock-up
• Steering
• Main hydraulic
• Pilot
• Brake cut-in & cut-out
• Brake accumulator
• Ride control accumulator
• Fan min & max speeds

The following repairs were completed by Marcel Equipment on this 980M Caterpillar:
Line bored front & rear steering cylinder mounting bores
Installed NEW pins & bearings on steering cylinders
Cleaned & inspected HVAC system & installed NEW filters
Installed NEW hydraulic tank vent filter
Inspected cab & all switch functions
REBUILT seat assembly
Repaired window washers & installed NEW wipers
Completed miscellaneous minor repairs on machine
This unit is ready to go to work

Machine out for rent & returned at 8,079 hours
Serviced engine
Fuel filters
Both engine air filters
Cab filters
General check over
Inspection
Completed any needed repairs... See More