WARRANTY INCLUDED - NEW Engine Installed in March 2014 at 5110 Hours - 8775 Hours - ECM Idle Hours: 2318 - Equipped with:
Caterpillar C11 ACERT Engine
Engine Block Heater
Cab (ROPS) with Air Conditioning
Hydraulic Disc Brakes
750/65R25 Wide Tires
100% Differential Lock on all Axles
30 Ton Capacity
12-24 Volt Receptacle
Rear View Camera
Engine Air Intake Emergency Stop (PAS)
Rear Window Guard
Lights, Mirrors, Heater
AM/FM Radio, Wipers
Rated at 325 GHP.
Approximately 50,000 LBS.
Repair / Condition Report
CAT dealer installed a CAT exchange engine in March 2014 at 5110 hours.
Following are the service and repairs completed in March 2018 at 8737 hours:
Unit was serviced:
Transmission filter was cut open and checked for contaminates, it was clean.
Hydraulic filter was cut open and checked for contaminates, it was clean.
All three differential oil levels were good and oils were clean.
All six wheel planetary oil levels were good and oils were clean.
Changed the fuel filters.
Changed the air filters.
Installed a NEW fuel gauge sender.
Installed a NEW radio.
Checked all gauges, switches, lights, controls, etc. for proper operation.
Checked the air conditioning and heater and they were good.
Installed a NEW lighter.
Checked the 6 wheel drive and it is operating properly.
Checked the engine belts, idlers, tensioners and they were all good.
Checked the articulation and oscillation and they were good.
A NEW sensor was installed on top of the control valve.
Checked the windshield washer for proper operation.
Checked all grease lines and greased unit.
Following are the pressure results taken:
Hoist Pressure = 3000 PSI - Specs: (3000+-100 PSI)
Steering Pressure = 3000 PSI - Specs: (3000+-100 PSI)
Pilot Pressure = 650 PSI - Specs: (500+-100 PSI)
Trans Pump = 220-255 PSI - Specs: (220-280 PSI)
Trans Lube = 3-22 PSI - Specs: (1-28 PSI)
Torque Inlet = 16-70 PSI - Specs: (13-75 PSI)
Torque Outlet = 5-30 PSI - Specs: (3-35 PSI)
Engine Oil = 28-56 PSI - Specs: (9-87 PSI)
High Idle = 2155 RPM - Specs: (2155+-40 RPM)
Fan Speed at Idle = 650 RPM - Specs: (600+-100 RPM)
Fan Speed at High Idle = 1840 RPM - Specs: (1800+ and Up)
To view this unit on our website, please visit: http://www.marcelequipment.com/equipment/cat-730-articulated-truck-t0110-2011.html
Looking for Equipment Financing? Browse our leading Equipment Finance Companies.