The Supply Post: Canada's #1 Heavy Contruction Equipment & Commercial Truck Newspaper Since 1971

2012 Caterpillar 730 Permanent URL

  • 2012 Caterpillar 730 $210,000 CAD

    WARRANTY INCLUDED - Ex-Municipal Unit with 9085 Hours - ECM Idle Hours: 4569 - Equipped with:
    Caterpillar C11 ACERT Engine
    Powershift/Autoshift Transmission
    Cab (ROPS) with Air Conditioning
    Hydraulic Disc Brakes
    Retarder
    30 Ton Capacity
    23.5 x 25 Tires - 2 NEW Front Tires Installed
    Tailgate
    Rear Window Screen
    Mirrors, Lights, Wipers, Heater
    Beacon Safety Light, AM/FM Radio
    Rated at 325 GHP.
    Approximately 50,000 LBS.

    Repair / Condition Report
    Installed 2 NEW 23.5 x 25 front tires.
    Upon arrival to our yard, this unit was powerwashed, serviced and checked over.
    Engine filter was cut open and checked for contaminates, it was clean.
    Transmission filter was cut open and it was clean.
    Hydraulic filter was also cut open and checked and it was clean as well.
    All 3 differential oil levels were good and oils were clean.
    All 6 wheel planetary oil levels were good and oils were clean.
    Replaced the center differential vent hose.
    REBUILT the center articulation using NEW pins and bearings.
    Linebored and installed NEW pins and bearings on the dump box hinge.
    Linebored and installed NEW pins and bearings on the box lift cylinders.
    Installed a NEW transfer case suction hose.
    Removed the transfer case and resealed and installed NEW clutch plates for the diff lock.
    Installed NEW tail lights.
    Repaired the beacon light.
    Installed a NEW U joint at the transfer case outlet.
    Checked the accumulator pressures.
    Checked all grease points and greased unit.
    Checked the 6 wheel drive and all is working well.
    Installed a REBUILT starter.
    Installed NEW batteries.
    Transmission and hydraulic pressure tests were taken:
    Torque Inlet Pressure - High Idle = 65 PSI - Specs: (70+-5 PSI)
    Torque Inlet Pressure - Low Idle = 24 PSI - Specs: (18+-5 PSI)
    Torque Outlet Pressure - High Idle = 25 PSI - Specs: (30+-5)
    Torque Outlet Pressure - Low Idle = 3 PSI - Specs: (5+-2)
    Lube Pressure - High Idle = 18 PSI - Specs: (23+-5 PSI)
    Lube Pressure - Low Idle = 3 PSI - Specs: (3+-2 PSI)
    Transmission Pump - High Idle = 280 PSI - Specs: (260+-20 PSI)
    Transmission Pump - Low Idle = 230 PSI - Specs: (240+-20 PSI)
    Hoist Pressure = 3050 PSI - Specs: (3000+-100)
    Steering Pressure = 3100 PSI - Specs: (3000+-100)
    Hoist Pilot = 650 PSI - Specs: (500+-100)
    High Idle = 2157 RPM - Specs: (2155+-40 RPM)
    Removed and resealed the transmission as it was seeping between sections.
    Removed and REBUILT the transfer case.
    Installed a NEW left front shock bearing.
    Installed a REBUILT starter.
    Installed NEW batteries.
    Replaced the left cylinder bushings.
    Replaced the brake pads on the rear axle assembly.
    Resealed the brake caliper on the right rear axle.
    This is a good clean unit that is ready to work.
    To view this unit on our website, please visit: http://www.marcelequipment.com/equipment/cat-730-articulated-truck-t2187-2008.html

    Request More Info | 519-686-1123 |
    For Sale Or Rent
    • Make: Caterpillar
    • Model: 730
    • Type: Trucks - Articulated
    • Class: Used
    • Status: For Sale Or Rent
    • Hours: 9085
    • Stock #: T2187
    Marcel Equipment Limited - London
    1000 Progress Drive
    London, ON  N6N 1B8 Canada
    Contact Name: Mark / John
    Phone: 519-686-1123
    Toll Free: 1-800-265-5747
    Fax: 519-686-9350
    Last Updated: September 19, 2018
    Supplypost.com Views: 89 | Dealer Website Views: 0

Looking for Equipment Financing? Browse our leading Equipment Finance Companies.

Permalink

This page's URL will never change unless this listing is deleted. Feel free to share it knowing https://www.supplypost.com/listings/877861/2012-caterpillar-730 will always end up at the same listing!