WARRANTY INCLUDED - 4542 Hours - Equipped with:
John Deere 6068T Engine
Counter Rotation Steering
30" Single Bar Grouser Pads
NEW Midwestern M540C Draw Works
24 Foot Boom
Draw Works and Boom Certified
40,000 LB. Lifting Capacity
John Deere Powershift Winch is Available
6 Way PAT Blade
Rated at 123 HP.
Approximately 28,300 LBS.
Note: Current Hour Meter Reads: 1836 Hours - Hour Monitor Replaced by John Deere at 2710 Hours - Total Machine Hours: 4542
Repair / Condition Report
Following is the list of repairs and servicing completed by Marcel Equipment Limited:
Serviced the engine, transmission and hydraulics. Filters from all three were cut open and all were clean.
Checked the final drive oil levels and they were all good and oils were clean.
Changed the primary and secondary fuel filters.
Changed the outer air filter.
Resealed the fuel filter housing.
Resealed the hydraulic control valve.
Replaced the hydraulic hose at the traction motor.
Replaced the angle cylinder grease line.
NEW pin and bearing installed on the angle cylinder barrel end.
Replaced the cutting edges.
Replaced the blade pins and bearings.
Checked the parking brake.
One of the pumps was not stroking properly so we replaced the transmission control module.
Installed a NEW Midwestern M540C Draw Works with a 24 foot boom.
This unit is now ready to work.
To view this unit on our website, please visit: www.marcelequipment.com
Looking for Equipment Financing? Browse our leading Equipment Finance Companies.